Avaya Configuring MPLS Services Manuel d'utilisateur télécharger pdf (Page 38)

Configuring MPLS Services

3-2

305754-A Rev 00

Customizing LDP Parameters

LDP is a protocol governing the set of procedures and messages by which

label-switching routers (LSRs) establish label-switched paths (LSPs) through a

network. LDP establishes these paths by mapping network layer routing

information directly to data link layer switched paths.

You can customize the default values for LDP parameters, as described in the

following sections.

Disabling and Reenabling LDP

By default, you enable LDP when you add an LDP session to the interface.

However, you can disable and reenable the LDP session at any time. Enable the

session to allow MPLS LDP to operate over the interface. Disable the session to

turn off MPLS LDP on the interface.

To disable or reenable LDP, complete the following tasks:

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

click on the ATM interface (

ATM1

) that you

want to modify.

The Select Connection Type window

opens.

2. Click on

MPLS

. The Edit MPLS Connector window opens.

3. Click on

LDP

. The LDP Session Records List window

opens.

4. Set the

Enable/Disable

parameter. Click

Help

or see the parameter description

on page A-2.

5. Click on

Done

. You return to the Edit MPLS Connector

window.

6. Click on

Done

. You return to the Select Connection Type

window.

7. Click on

Done

. You return to the Configuration Manager

window.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Avaya Configuring MPLS Services Manuel d'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya Configuring MPLS Services