Avaya Configuring MPLS Services Manuel d'utilisateur télécharger pdf (Page 45)

Customizing the MPLS Configuration

305754-A Rev 00

3-9

Specifying a Protocol for MPLS Route Configuration

You can specify the protocol that LDP uses to configure routes or allow LDP to

use both a protocol and IP static routes.

Accept the default, OSPF, for OSPF routing. Specify RIP to use the routing

information protocol. When using either the OSPF or RIP setting, LDP does not

use any of the IP static routes in the route table.

To use static routes based on the entries in the forwarding information base (FIB)

along with OSPF, specify HYBRIDOSPF. To use static routes along with RIP,

specify HYBRIDRIP.

To specify a protocol for route configuration, complete the following tasks:

Note:

The routes configuration mode takes precedence over the protocol that

you set (see “

Specifying the Routes Configuration Mode” on page 3-7). This

means that when you set the routes configuration mode to Manual, LDP

disregards the protocol setting.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

click on the ATM interface (

ATM1

) that you

want to modify.

The Select Connection Type window

opens.

2. Click on

MPLS

. The Edit MPLS Connector window opens.

3. Click on

LDP

. The LDP Session Records List window

opens.

4. Set the

Protocol

parameter. Click on

Help

or see the parameter description on

page A-5.

5. Click on

Done

. You return to the Edit MPLS Connector

window.

6. Click on

Done

. You return to the Select Connection Type

window.

7. Click on

Done

. You return to the Configuration Manager

window.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 91 92

Commentaires sur ces manuels

Pas de commentaire

Avaya Configuring MPLS Services Manuel d'utilisateur Page 45

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya Configuring MPLS Services