Avaya Configuring Data Compression Services Manuel d'utilisateur télécharger pdf (Page 97)

Monitoring Software Compression Using the BCC show Commands

117352-D Rev. 00

C-5

show wcp stats error2

The

show wcp stats error2

command displays information about error

conditions pertaining to WCP compression on the connection.

The output includes the following information:

Data Out of Sequence Number of instances registered of the data-out-of-sequence

condition.

Rexmit Out of

Sequence

Number of times that an acknowledgment was retransmitted out

of sequence.

Rexmit Time-Outs Number of timeout messages retransmitted.

Exceeded Ks Number of times that K was exceeded. (WCP maintains a

transmit history of data packets for a specified range called “K.” A

packet can be retransmitted if it remains in the range of packets

kept in the transmit history. If a packet is outside the range

specified by K, it cannot be retransmitted.

Channel Number The number of the channel on which this virtual circuit is running.

Circuit Name Circuit name of the interface.

Vc Id Identification of the virtual circuit.

Reset Packets (Tx) Number of reset packets transmitted.

Reset Packets (Rx) Number of reset packets received.

Re-transmit Request

(Tx)

Number of retransmit request packets transmitted.

Re-transmit Request

(Rx)

Number of retransmit request packets received.

Re-transmit Naks (Tx) Number of negative acknowledgments transmitted

Re-transmit Naks (Rx) Number of negative acknowledgments received

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 103

Pas de commentaire

Avaya Configuring Data Compression Services Manuel d'utilisateur Page 97