Avaya Configuring Data Compression Services Manuel d'utilisateur télécharger pdf (Page 76)

Configuring Data Compression Services

A-14

117352-D Rev. 00

PPP Interface Parameters for Compression

The PPP Interface Lists window contains two parameters for data compression.

(For more information about PPP, see

Configuring PPP Services

To access the PPP Interface Lists window, complete the following tasks:

The PPP parameters for compression are as follows.

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

PPP

. The PPP menu opens.

3. Choose

Interfaces

. The PPP Interface Lists window opens.

Parameter: CCP Type

Path: Configuration Manager > Protocols > PPP > Interfaces

Default: CCP

Options: ILCCP

CCP

Function: Specifies the compression control protocol that the router uses for this interface.

Instructions: Accept the default, CCP, if you select Hi/fn LZS as the compression protocol, or

if you select WCP as the compression protocol and you set the PPP Mode

parameter to multilink. Using CCP as the compression type means that the

router negotiates compression above the multilink bundle.

Select ILCCP if you are configuring a new circuit and you set the PPP Mode

parameter to multilink, and the remote router is using router software earlier

than Version 12.10. Using ILCCP as the compression type means that the router

negotiates compression below the multilink bundle.

If you have a router running BayRS Version 12.10 or later using an older

configuration file, the routers negotiate WCP below the multilink bundle by

default. You can change this to CCP for the routers at both ends of the link to

negotiate WCP above the multilink bundle.

MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.71

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 102 103

Pas de commentaire

Avaya Configuring Data Compression Services Manuel d'utilisateur Page 76