Avaya Configuring Data Compression Services Manuel d'utilisateur télécharger pdf (Page 71)

Site Manager Parameters

117352-D Rev. 00

A-9

The parameter descriptions follow.

Parameter: Enable

Path: Configuration Manager > Protocols > WCP > Interfaces

Default: Enable

Options: Enable

Disable

Function: Enables or disables data compression on the circuit.

Instructions: WCP automatically sets this parameter to Enable when you select WCP in the

Select Protocols window. If you want to temporarily disable WCP rather than

delete it from the router, set this parameter to Disable. Reset it to Enable to

reenable WCP.

MIB Object ID: 1.3.6.1.4.1.18.3.4.22.2.1.2

Parameter: Compression Mode

Path: Configuration Manager > Protocols > WCP > Interfaces

Default: Inherit from Line

Options: Continuous Packet

Packet by Packet

Inherit from Line

Function: Specifies the compression mode on the circuit.

Continuous packet compression (CPC) retains compression history across

packets and allows a higher compression ratio than packet-by-packet

compression (PPC).

Packet-by-packet compression (PPC) resets compression history at the start of

each packet, resulting in a lower compression ratio. Because PPC does not

depend on previous packets, you should select this option for a link that drops a

large number of packets.

Inherit from Line allows you to set WCP parameters at the line level and apply

them to circuits. For PPP, with only one circuit per line, this means that you can

configure WCP at either the circuit level or the line level.

Instructions: Select Inherit from Line if you want to accept the value in effect for the WCP

Compression Mode line parameter. Otherwise, select either Continuous Packet

or Packet by Packet.

MIB Object ID: 1.3.6.1.4.1.18.3.4.22.2.1.4

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 102 103

Pas de commentaire

Avaya Configuring Data Compression Services Manuel d'utilisateur Page 71