Avaya Configuring Data Compression Services Manuel d'utilisateur télécharger pdf (Page 95)

Monitoring Software Compression Using the BCC show Commands

117352-D Rev. 00

C-3

show wcp vcs

The

show wcp vcs

command displays information about virtual circuits running

WCP compression.

The output includes the following information:

Slot/<Mod>/

Connector

Interface identified by slot, module, and connector.

Channel Number Number of the channel on which this virtual circuit is running.

Circuit Name Circuit name of the interface.

Vc Id Identification of the virtual circuit.

Compression State State of the compression software on the virtual circuit:

• data (data is being compressed)

• disabled (compression software is inoperative)

• disconnected (compression is not connected to the virtual

circuit)

• init (compression software is initializing)

• nak (compression software is returning a negative

acknowledgment)

Decompression State State of the decompressing software on the virtual circuit:

• data (data is being decompressed)

• disabled (decompression software is inoperative)

• disconnected (decompression is not connected to the virtual

circuit)

• init (decompression software is initializing)

• rexmit (decompression software is retransmitting)

• reset (decompression software has been reset)

• connecting (decompression software is connecting to the

virtual circuit)

• disconnecting (decompression software is disconnecting from

the virtual circuit)

Actual Comp Mode Compression mode operating on the circuit: continuous packet

compression (CPC) or packet-by-packet compression (PPC).

Actual Hist Size Amount of memory allocated to compression history for the

circuit.

Actual Engine Type Type of compression operating on the circuit: hardware or

software.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 101 102 103

Pas de commentaire

Avaya Configuring Data Compression Services Manuel d'utilisateur Page 95