Avaya Using Technician Interface Software Manuel d'utilisateur télécharger pdf (Page 32)

Using Technician Interface Software

1-6

308657-14.00 Rev 00

Newly installed routers initially do not require SecurID authentication for

Technician Interface login privileges. (The network administrator must first enable

the feature on the router.)

We recommend SecurID authentication for routers that require the highest level of

protection from unauthorized Telnet access to the Technician Interface. To support

Technician Interface login via SecurID, you must have a Security Dynamics

SecurID ACE

server system installed on your IP network. Routers with the

SecurID ACE client enabled communicate with the SecurID server during each

user authentication sequence.

For more information about SecurID server systems, contact your Nortel

Networks sales representative.

SecurID Login and PIN Assignment Dialog

This section describes more fully the dialog that may occur when you try to login

to a router configured with SecurID client software. Normally you can open a

Technician Interface session as long as you enter a valid PASSCODE (your PIN,

followed by the current cardcode). If you do not have a valid SecurID PIN when

you attempt the login, you may receive another series of prompts for automated

PIN assignment.

Note: The SecurID administrator for your network must first configure the

SecurID system to allow you to receive a PIN through the SecurID client

software on the router.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 343 344

Pas de commentaire

Avaya Using Technician Interface Software Manuel d'utilisateur Page 32