Avaya Using Technician Interface Software Manuel d'utilisateur télécharger pdf (Page 310)

Using Technician Interface Software

C-22

308657-14.00 Rev 00

Reenabling Syslog on the router

• Transitions Syslog hosts and their filters to an ACTIVE operational state in

the router configuration. (Only n Syslog host entries transition to the ACTIVE

state, where n = the value of wfSyslogMaxHosts.)

• Resumes all message forwarding from Syslog to Syslog hosts configured on

the router. (Syslog forwards messages to n hosts only, where n = the value of

wfSyslogMaxHosts.)

Disabling or Reenabling Syslog Hosts or Filters

You can disable or reenable host or filter entries already defined in your Syslog

configuration as follows:

Disable or reenable message forwarding to a Syslog host, as follows:

• Disable a Syslog host anytime after adding it to the router configuration

by entering the following command line:

$: set wfSyslogHostEntry.wfSyslogHostDisable.

2;commit

Disabling a host:

• Transitions the operational state of that Syslog host entry and its

corresponding filters to INACTIVE

• Stops Syslog from forwarding event messages to the host

• Reenable message forwarding to a specific Syslog host by entering the

following command line:

$: set wfSyslogHostEntry.wfSyslogHostDisable.

1;commit

Reenabling a host:

• Transitions the operational state of that Syslog host entry and its

corresponding filters to ACTIVE

• Allows Syslog to resume forwarding event messages to the host

Disable or reenable an entity filter for a specific Syslog host, as follows:

• Disable an entity filter anytime after adding it to the router configuration

by entering the following command line:

1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 343 344

Pas de commentaire

Avaya Using Technician Interface Software Manuel d'utilisateur Page 310