Avaya Configuring Interface and Router Redundancy Manuel d'utilisateur télécharger pdf (Page 45)

Configuring Router Redundancy

5-7

Parameter: Send PDU Enable

Default: Enable

Options: Enable | Disable

Function: Enables or disables sending of router redundancy protocol data units

(PDUs) on a per-circuit basis. This parameter is automatically set to

Enable when you select Router Redundancy from the Select Protocols

window.

At least one interface on each router in the group must have this

parameter enabled so that all routers in the group receive status

information about each other. You may want to disable this parameter on

some redundant interfaces to minimize network trafﬁc on a busy

interface.

Instructions: Select Enable or Disable.

MIB Object ID: 1.3.6.1.4.1.18.3.5.17.2.1.5

Parameter: Primary MAC Address

Default: None

Options: Any unique, 48-bit MAC address that the network manager provides

Function: The primary router uses the MAC address to route data. When the

primary router fails and a backup router becomes the new primary router,

the new primary router assumes this MAC address.

Instructions: Enter a unique MAC address.

MIB Object ID: 1.3.6.1.4.1.18.3.5.17.2.1.4

Note: If you are running DECnet on this interface, make sure the MAC

address matches the MAC address used in the DECnet conﬁguration.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 71 72

Pas de commentaire

Avaya Configuring Interface and Router Redundancy Manuel d'utilisateur Page 45