Avaya Configuring Interface and Router Redundancy Manuel d'utilisateur télécharger pdf (Page 43)

Configuring Router Redundancy

5-5

The Enable and Send PDU Enable parameters are set to Enable, as they must

be for router redundancy to work.

10. Enter the Primary MAC Address for the router (required).

Use the parameter description that follows these directions for guidelines.

11. Click on OK.

The R.R. Group Global Parameters Conﬁguration window appears

(Figure

5-5).

Figure 5-5. R.R. Group Global Parameters Conﬁguration Window

Site Manager supplies default values for all parameters.

12. Enter values for any parameters you want to edit, using the descriptions

that follow this procedure for guidelines.

Note: The Conﬁguration Mode appears in the Conﬁguration Manager

window, the Add Circuit window, and the Router Redundancy Circuit window

as “group.” You cannot add router redundancy to a circuit or edit redundancy

parameters in any mode other than group mode.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 71 72

Pas de commentaire

Avaya Configuring Interface and Router Redundancy Manuel d'utilisateur Page 43