
Configuring IP Exterior Gateway Protocols (BGP and EGP)
6-18
308628-14.00 Rev 00
For example, the following command disables loop detection on peer-to-peer
session 2.2.2.2/2.2.2.4:
peer/2.2.2.2/2.2.2.4# detect-as-loop disabled
peer/2.2.2.2/2.2.2.4#
Using Site Manager
Specifying the Route Reflector Mode of the Remote Peer
For complete information about configuring a route reflector, see Chapter 8,
“Configuring a Route Reflector.”
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
BGP
. The BGP menu opens.
4. Choose
Peers
. The IP Interface List for BGP window
opens.
5. Click on the IP interface for which you
want to edit BGP peer parameters.
6. Click on
BGP Peers
. The BGP Peer List window opens.
7. Click on the peer for which you want to
edit parameters.
The parameters for that peer appear in
the window.
8. Set the
Loop Detection
parameter. Click
on
Help
or see the parameter description
on page A-16
.
9. Click on
Apply
, and then click on
Done
. Site Manager returns you to the IP
Interface List for BGP window.
Commentaires sur ces manuels