Avaya Configuring Dial Services Manuel d'utilisateur Page 61

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 326
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 60
114062 Rev. A 3-1
Chapter 3
Implementation Notes
for All Dial Services
This chapter provides information about Bay Networks implementations for all
three dial services.
Point-to-Point Protocol
Site Manager automatically configures the Point-to-Point Protocol (PPP) on lines
in a demand pool and bandwidth pool, including ISDN B channels. For lines in a
backup pool, PPP is not automatically configured; you select it. PPP routes or
bridges datagrams over point-to-point lines and runs all routing/bridging protocols
that it supports. Synchronous and asynchronous interfaces use PPP.
Dial circuits use a PPP identification mechanism to identify the calling router to
the called router. The identification method relies on one of two PPP
authentication protocols -- Challenge Handshake Authentication Protocol
(CHAP) or Password Authentication Protocol (PAP). These authentication
protocols implement a security feature that identifies peer routers to one another.
The identification process takes place during PPP link negotiation, which occurs
before the routers establish a connection to send data. It enables the destination
router to identify the caller dynamically, allowing a single dial interface (ISDN or
modem) at a remote router to serve as the connection point to multiple routers. For
a router to identify callers, you must fill in the router’s caller resolution table.
When you configure dial services, Site Manager automatically creates a PPP line
record that all pools use. This is a generic record that a circuit uses for
identification.
Vue de la page 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 325 326

Commentaires sur ces manuels

Pas de commentaire