Avaya BayStack ARN Routers Manuel d'utilisateur télécharger pdf (Page 69)

Starting the ARN

114200-C Rev 00

2-13

When the ARN boots, its LEDs flash in a particular order. To ensure that the

installation was successful, see “Ensuring a Successful Installation” on page

3-9.

Ensure that the ARN is successfully connected to your network.

To verify that the ARN is now connected to the network, contact your network

administrator. To troubleshoot any problems, your network administrator can

refer to Configuring BayStack Remote Access.

If you need additional assistance, contact your local Bay Networks Technical

Solutions Center.

Continuing with Local Boot (the Quick-Start Procedure)

You can use either the ARN monitor or the Technician Interface to configure the

ARN to local boot. However, you must use the Technician Interface to run the

Quick-Start script.

Note:

After connecting the ARN to the network, you can replace the

management console connection with a modem connection to enable remote

dial-in access.

Note:

Continuing with the netboot option requires that you have already

logged in to either the ARN monitor or Technician Interface command line

software. For instructions, see “Logging in to the Command Line Software” on

page 2-7.

Note:

Before starting the local boot procedure, ask your network administrator

to assist you in completing the Quick-Start worksheets in Appendix B.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 161 162

Pas de commentaire

Avaya BayStack ARN Routers Manuel d'utilisateur Page 69