Avaya BayStack ARN Routers Manuel d'utilisateur Page 68

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 162
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 67
Installing and Operating BayStack ARN Routers
2-12
114200-C Rev 00
Figure 2-1. Verifying Directed Netboot Configuration
If getcfg displays the correct information, continue to Step 4. Otherwise,
correct and reenter the
ifconfig and bconfig commands. If you need
assistance, contact your network administrator.
4.
Type the following command and press the Return key to boot the ARN:
boot
5.
Ensure that the ARN boots correctly.
Note:
If the ARN cannot find a software image file or a configuration file
using the directed netboot procedure, it attempts to netboot once. If the netboot
procedure fails, the ARN tries to local boot once. If all three boot attempts fail,
the ARN continues to try directed netboot, netboot, and local boot until it
boots successfully. If the ARN remains in this loop, follow the steps in
“Interrupting the Boot Process” on page 2-6.
ARN0080A
$ getcfg
Boot Options
boot image = network
boot config = network
host IP address = 192.32.5.8
image pathname =
"/usr/arnstartup/krnl_arn.exe"
config pathname =
"/usr/arnstartup/config"
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...IP=9.0.0.2, Mask=255.0.0.0, Next Hop=9.0.0.3
COM2...EZ-Install (disabled)
COM3...EZ-Install (disabled)
COM4...EZ-Install (disabled)
COM5...EZ-Install (disabled)
Vue de la page 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 161 162

Commentaires sur ces manuels

Pas de commentaire