Avaya BayStack ARN Routers Manuel d'utilisateur télécharger pdf (Page 81)

Operating the ARN

114200-C Rev 00

3-9

Ensuring a Successful Installation

After connecting the ARN to the network, you can ensure a successful installation

by checking the diagnostic LEDs on the front panel of the base module (refer to

Figure 3-1 on page 3-2).

When you power on the ARN, the following sequence of front panel LED activity

should occur:

• All base module LEDs light momentarily; this tests that the LEDs are

operational.

• The Run, Boot, and Fail LEDs count through a short, initial startup sequence.

• The Pwr (power) LED lights and remains on.

• The Run LED begins flashing and continues to flash until the ARN completes

all diagnostic tests.

• As the diagnostic procedure tests each module, the LED representing that

module flashes slowly. If the module passes its diagnostic test, the LED

remains on. If the module fails its diagnostic test, the Fail LED remains on

and the module LED flashes rapidly.

Table 3-14. V.34 Modem LEDs

LED Meaning

(Transmit)

Lights when the V.34 modem

interface transmits data over the

network.

(Receive)

Lights when the V.34 modem interface receives data from the

network.

RLSD

(Received Line

Signal Detection)

Lights when the modem activates.

DTR

(Data Terminal Ready)

Lights when the V.34 modem interface is ready to transmit

data.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 161 162

Pas de commentaire

Avaya BayStack ARN Routers Manuel d'utilisateur Page 81