Avaya S8710 Manuel d'utilisateur télécharger pdf (Page 34)

Configuring the media server

34 Installing and Configuring the Avaya S8700 or S8710 Media Server

June 2004

Powering up the media server

1 S8700: Connect the AC power cord to media server 1 and to UPS 1 to power it up.

S8710: Connect the AC power cord to media server 1 and to UPS 1. Press the Power button on the

front to power it up.

Accessing the media server

NOTE:

You must place the CD in the drive immediately.

1 Connect the laptop to the services port (port 2 [Eth1]) on the back of the media server using a

crossconnect cable.

2 Place the CD with Avaya Communication Manager in the CD-ROM drive on the media server.

3 Wait at least 3 minutes after powering up before starting a Telnet session to access the information

on the CD.

Setting up Telnet

NOTE:

Use a telnet session to access the information on the CD.

The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF) each time

you press Enter. The installation program sees this as 2 key presses. If running Windows 2000/XP, you

need to correct this before you copy the Remaster Program to the hard drive.

1 Click Start > Run to open the Run dialog box.

2 Type telnet and press Enter to open a Microsoft Telnet session.

3 Type display and press Enter to see the current settings. If message says

Sending only CR

then close the dialog box.

If message says

Sending both CR & LF

then continue with step 4.

4 Type unset crlf and press Enter.

5 Type display and press Enter to verify that the settings changed. The message says

Sending only CR

6 Close the dialog box.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 95 96

Pas de commentaire

Avaya S8710 Manuel d'utilisateur Page 34