Avaya BSGx4e CLI Guide de l'utilisateur télécharger pdf (Page 135)

3 Configuration commands SNMP commands

NN47928-107 135

snmp agent

Use this command to configure an SNMP agent. The SNMP agent MIBs are

described in IETF RFC 1213.

The SNMP agent replies only to SNMP version 2c requests. Apart from the

system group, all MIBs are in read-only mode in this version.

Note: The BSGX4e cannot be configured through SNMP. The port used by

the SNMP agent must be opened in the Firewall, allowing SNMP clients to

reach it.

Syntax config snmp agent enabled [yes|no] port <number> sysloc

<location> syscon <contact> sysname <name>

Parameters enabled yes|no Enable or disable the agent. The default is

enabled.

port number Enter the port or range of ports on which the

agent listens. The default port is 161.

sysloc location Enter the SNMP system location (sysLocation

MIB); physical location of the hardware.

syscon contact Enter the SNMP system contact (sysContact

MIB); contact person for this hardware.

sysname name Enter the SNMP system name (sysName MIB);

administrator assigned to this hardware.

Example > config snmp agent enabled yes port 161

commands

clear snmp agent

display snmp agent

show snmp agent

stats snmp agent

show snmp community

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 183 184

Pas de commentaire

Avaya BSGx4e CLI Guide de l'utilisateur Page 135