Avaya Using Technician Interface Software Manuel d'utilisateur télécharger pdf (Page 266)

Using Technician Interface Software

B-4

The xmodem Command

The following represents the syntax of the xmodem command:

For out-of-band ﬁle transfer operations, use only the

xmodem command

parameters and options that are appropriate for

• The YMODEM protocol

• The type of ﬁle you need to transfer

The relevant

xmodem command parameters are sb (send binary) and rb (receive

binary). The relevant option ﬂags are

y (ymodem), l (logging), w (wait before

initiating transfer),

p (print/display xmodem information and events), n (allow

midtransfer cancel), and

e (disable EOT veriﬁcation — DOS only).

The

y and w option ﬂags are required in the xmodem commands (to select

YMODEM, and for proper handshaking with the YMODEM protocol program

running on the remote workstation). You should use the

p option to monitor the

progress of any out-of-band ﬁle transfer in progress (UNIX only).

You can enable or disable logging of

xmodem events by means of the l ﬂag, or

cancel a particular ﬁle transfer by entering control-x.

Note: You can enter the xmodem command line parameters and option ﬂag

characters in upper- or lower-case. Do not insert spaces between parameter

characters, between option ﬂag characters, or between a parameter and an

option ﬂag character. Do insert a space character after the last option ﬂag and

between ﬁlenames (for YMODEM batch ﬁle transfers).

Command

Options

Subcommands

Files to send

Files to receive

Files to receive as

Source Volume

and Source Directory

xmodem [sb | st | rb | rt ]

< y | m | k | c | l | w | p | e | n > <vol/dir>: <filename> <filename>

...

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 351 352

Pas de commentaire

Avaya Using Technician Interface Software Manuel d'utilisateur Page 266