
GeoTel Features User Manual TCAD Alarm Messages
P0602482 Ver. 04.03 Avaya Page 449
TMS in slot # received restart command
• The TMS received a command to restart. This message helps differentiate
between soft reset and a hard reset (e.g., a power cycle, using the reset button).
This is normal after receiving a restart request. No action required.
Hardware Health check failed for TMS in slot #
• The NIC has detected a failure on the hardware health check status of a TMS.
See “TMS Health Check” on page 452.
TMS Resource faulty not responding to commands
• A resource(s) on a TMS is not responding to commands. See “TMS Health
Check” on page 452.
TMS received start up command
• The TMS received a start up request command from the user. No action
required.
TMS received shut down command
• The TMS received a shut down request command from the user. No action
required.
The following messages indicate that the previous error conditions are clearing/have
cleared.
Clearing Hardware Initialization failure for FPGA
Clearing Device Driver software interface failure to load
Clearing Device Driver interface software failure to
initialize
Clearing Package Memory Manager (PMM) failure to
initialize
Clearing DTC Simulator (SIM) failure to initialize
Clearing Alarms, Diagnostics and Statistics Management
(ADSM) failure to initialize
Clearing Phase Lock Loop Controller (PLL) failure to
initialize
Clearing Digital Communications Controller (DCC) failure
to initialize
Commentaires sur ces manuels