Avaya Configuring IP Utilities Manuel d'utilisateur Page 32

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 228
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 31
Configuring IP Utilities
1-10
308631-14.00 Rev 00
Starting NTP Services
You can use the BCC or Site Manager to configure NTP on the router, accepting
default values for all parameters. If you decide to change some or all of the default
values, see Chapter 7, “Customizing NTP Services.”
Before you begin, verify that:
IP is configured on an interface. For instructions, see “Configuring IP for
Global Protocols” on page 1-2.
The remote time servers that you want to configure on the network are
reachable via IP.
To do this, you must ping the IP address of the time server that you want to
configure. If the time server is not on the local network, you must configure
the appropriate IP routing protocol, such as RIP or OSPF. For information
about configuring routing protocols, see Configuring IP, ARP, RARP, RIP, and
OSPF Services.
Using the BCC
To start NTP services on the router with default settings, begin in configuration
mode at the box or stack prompt:
1.
Configure NTP
.
box#
ntp
ntp#
2.
Display NTP default settings
.
ntp#
info
state enabled
ntp#
Vue de la page 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 227 228

Commentaires sur ces manuels

Pas de commentaire