Avaya Configuring IP Utilities Manuel d'utilisateur télécharger pdf (Page 110)

Configuring IP Utilities

6-20

308631-14.00 Rev 00

Customizing a Telnet Client on the Router

After you start a Telnet client on the router for outbound Telnet sessions, as

described in Chapter 1, default values are in effect for all Telnet client parameters.

You may want to change these parameter values, depending on the requirements

of your network.

The following sections describe information you supply and options you select

that affect the way a Telnet client runs on the router.

Disabling and Reenabling a Telnet Client on the IP Router

You can disable or reenable a Telnet client on the IP router. By default, the Telnet

client is enabled on the IP router, allowing you to establish Telnet sessions to the

target router.

Using the BCC

To disable a Telnet client, navigate to the client-specific prompt and enter:

disable

For example, the following command line disables a Telnet client:

client#

disable

client#

To reenable a Telnet client on the IP router and display its default values, navigate

to the client-specific prompt and enter:

enable

For example, the following command line reenables a Telnet client:

client#

enable

client#

info

debug-log-flag off

remote-port 23

prompt {}

state enabled

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 227 228

Pas de commentaire

Avaya Configuring IP Utilities Manuel d'utilisateur Page 110