Avaya CallPilot Message Networking Manuel d'utilisateur télécharger pdf (Page 46)

Chapter 4 Setting up AMIS

P0919429 06

To send a test network message using the AMIS Loopback mailbox -

CallPilot Mini

1 Dial the CallPilot Messaging access number, then enter your mailbox number and press

2 Enter your mailbox password and press

3 Press

4 Press

5 Enter the system phone number of the destination site and press

6 Press

7 Enter the Loopback mailbox number and press

8 Press

9 Press

10 Record your message and then press

11 Press

12 Hang up to end the session.

To determine if Network Messaging is working, open your mailbox. The message you record

returns as a message to your mailbox. If the message does not appear in your mailbox after five

minutes:

• ensure that the Network Delivery option is enabled.

• ensure that the Call Blocking periods at your site and at the receiving site allow Network

Messaging during the time you attempt to test the system. Call Blocking prevents calls being

sent during a specific time period.

• consider whether the test message is delayed by the period of the Retry interval. The Retry

interval is a Class of Service feature. For more information on Class of Service, refer to the

CallPilot Manager Set Up and Operation Guide.

• consider whether the test message is subject to line availability at your site or at the receiving

site.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 73 74

Pas de commentaire

Avaya CallPilot Message Networking Manuel d'utilisateur Page 46