Avaya Configuring IP, ARP, RIP, and OSPF Services Manuel d'utilisateur télécharger pdf (Page 266)

Configuring IP, ARP, RIP, and OSPF Services

A-26

117356-E Rev 00

Static Route Parameters

Parameter: Enable ISP Mode Support

Path: Configuration Manager > Protocols > IP > Global

Default: Disable

Options: Enable

Disable

Function: Enables and disables Internet service provider (ISP) features.

Instructions: Use this parameter to configure BGP as a soloist and to disable the use of

forwarding tables on IP interfaces.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.19

Parameter: Percentage of ARP Buffers

Path: Configuration Manager > Protocols > IP > Global

Default: 100

Options: An integer indicating the percentage of buffers

Function: Defines the upper limit (as a percentage) of buffers that ARP can use for saving

buffers when resolving ARP requests.

Instructions: Specify the percentage as an integer.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.27

Parameter: Enable

Path: Configuration Manager > Protocols > IP > Static Routes

Default: Enable

Options: Enable

Disable

Function: Specifies the state (active or inactive) of the static route record in the IP

routing tables.

Instructions: Select Disable to make the static route record inactive in the IP routing table;

the IP router will not consider this static route. Select Enable to make the

static route record active again in the IP routing table.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.5.1.2

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 361 362

Pas de commentaire

Avaya Configuring IP, ARP, RIP, and OSPF Services Manuel d'utilisateur Page 266