Avaya Configuring IP, ARP, RIP, and OSPF Services Manuel d'utilisateur télécharger pdf (Page 268)

Configuring IP, ARP, RIP, and OSPF Services

A-28

117356-E Rev 00

Parameter: Cost

Path: Configuration Manager > Protocols > IP > Static Routes > Add

Default: 1

Options: 1 to the value of the RIP Diameter parameter (maximum 127)

Function: Specifies the number of router hops that a datagram can traverse before

reaching the destination IP address. The IP router uses the cost value when

determining the best route for a datagram to follow.

Instructions: Enter the number of router hops.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.5.1.5

Parameter: Next Hop Addr

Path: Configuration Manager > Protocols > IP > Static Routes

Default: 0.0.0.0

Options: Any valid IP address

Function: Specifies the IP address of the next-hop router. Defines a black hole route for a

supernet.

Instructions: Enter the IP address in dotted-decimal notation. To configure a black hole

static route, enter 255.255.255.255. If you are configuring a static route to an

unnumbered interface, enter 0.0.0.0.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.5.1.6

Parameter: Next Hop Mask

Path: Configuration Manager > Protocols > IP > Static Routes

Default: 0.0.0.0

Options: Any valid subnet mask address

Function: Specifies the subnet mask of the next-hop router. This parameter also defines a

black hole route for a supernet.

Instructions: Enter the subnet mask in dotted-decimal notation. To configure a black hole

static route, enter 255.255.255.255. If you are configuring a static route to an

unnumbered interface, enter 0.0.0.0.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.5.1.7

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 361 362

Pas de commentaire

Avaya Configuring IP, ARP, RIP, and OSPF Services Manuel d'utilisateur Page 268