Avaya BCM50 Guide de configuration télécharger pdf (Page 7)

BCM50 to Mediatrix® Direct Gateway V1.0 June 2006

_______________________________________________________________________________________________________________________

External Distribution NORTEL

2.2 Objectives:

The objective of the testing and configuration was to extend analog capabilities to a Mediatrix ® analog gateway

from a BCM50 over a VoIP network. This allows users to deploy devices such as analog phones across a VoIP

capable network allowing a reduction in cable infrastructure.

2.3 Topology:

Figure 2

A PRI between the BCM400 and BCM50 was provisioned to provide external telephony access to the BCM50.

The BCM50 is Ethernet attached to the ES 470. The Mediatrix ® 1102 ® is Ethernet attached to the ES 470.

The BCM400 has an analog station module (ASM) to provide analog connectivity to the laptop. The analogue

device is attached to analog port 1 on the Mediatrix ®.

2.4 Configuration Steps:

2.4.1 BCM50 Configuration

2.4.1.1 Call Routing Configuration

The BCM50 will need to be configured with a call route to the gateway. In this setup, route 003 will be used with a

DN type of National. The DN type is very important when configuring trunks. The Mediatrix ® will also be

configured with a DN type of E.164 which is what is equivalent of National. These must match.

PRI

BCM 50 E

BCM 400

ES 470

Mediatrix

1102

Laptop

PRI

BCM 50 E

BCM 400

ES 470

Mediatrix

1102

PRI

BCM 50 E

BCM 400

ES 470

Mediatrix

1102

Laptop

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Pas de commentaire

Avaya BCM50 Guide de configuration Page 7