Send DMS-API Message 127
This function allows you to send an E2-data message to a peripheral
that is capable of receiving messages through this technology. The
web interface presents all DECT extensions that are defined in the
eKERNEL_DEVICE table for the local site and area and the output
program eDMSAPI.
ATTENTION
The eWEB application is configured in the eWEB table, and identifies its site and
area based upon the IP address of the Apache Web Server.
Therefore, it lists only those devices that are defined for that same site and
area. In a multi-area environment, you can access the devices that belong
to another area. You can assign these remote area devices on device
level in the eKERNEL_DEVICE table, where the DEV_Ras_Area_b value
must be set to
True.
Figure 142 "Local extensions" (page 127) shows the list of extensions that
all reside locally on the same site and area.
Figure 142
Local extensions
Figure 143 "Local and remote extensions" (page 127) shows the list
of extensions that all reside locally on the same site and area, but also
displays an extension that resides on another area, which is made
available through the DEC_Ras_Area_b value in the eKERNEL_DEVICE
table.
Figure 143
Local and remote extensions
Note: The Send DMS-API Message form always contacts that local
DMS-API Service of the same site and area as the Apache Web Server.
In a multi-area environment, where there are possible multiple eDMSAPI
applications defined, the local DMS-API service contacts all peripherals.
Nortel Communication Server 1000
DECT Messenger Installation and Commissioning — Book 2
NN43120-301 02.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.
Commentaires sur ces manuels