Avaya Configuring IP Services Manuel d'utilisateur Page 51

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 415
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 50
Starting IP Services
114065 Rev. A 2-5
Starting RIP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring Line Services.
The Select Protocols window opens.
1. Select IP and RIP from the Select Protocols window and click on OK.
Site Manager displays the IP Configuration window.
2. Edit the IP Configuration window as described in
“Starting IP” on page 2-3.
3. Click on OK.
Adding RIP to an IP Interface
To add RIP to an IP interface, begin at the Configuration Manager window and
proceed as follows:
1. Click on the connector to which you want to add RIP services.
2. Click on Edit Circuit.
3. Select Protocols > Add or Delete.
The Select Protocols window opens.
4. Click on RIP to select it.
5. Click on OK to exit the window.
6. Select File > Exit to exit the Circuit Definition window and return to the
Configuration Manager window.
Vue de la page 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 414 415

Commentaires sur ces manuels

Pas de commentaire