
Chapter 3 Setting up AMIS 39
CallPilot Message Networking Set Up and Operation Guide
Sending a test network message
To test network message capability you must send a message from your site to the Loopback
mailbox at a site on the AMIS network. When the Loopback mailbox at the destination site
receives the message, it automatically returns the message to the mailbox used at the originating
site. If you use the System Administrator's Mailbox, the test message you record is left as a
message in your System Administrator Mailbox. If you receive the message, it indicates Network
Messaging is operating properly. If you do not receive the message or if a protocol error occurs,
refer to “Troubleshooting Non Delivery Notification messages” on page 63.
Use the procedure that corresponds to your mailbox interface. For information on determining
which mailbox interface you use, see the CallPilot Reference Guide.
To send a test network message using the AMIS Loopback mailbox -
Norstar Voice Mail
1 Press ≤·°⁄.
Follow the voice prompts or the display button options to open
your mailbox.
2 Press REC
or ‹.
After the tone, record a message.
3 Press OK
or £ to end the recording.
4 Press OK
or £ to accept the recording.
5 Press ££.
6 Press AMIS
.
7 Enter the system phone number of the destination site
and press OK
or £.
8 Press OK
or £.
9 Enter the Loopback mailbox number and press OK
or £.
10 Press OTHR
or £.
11 Press SEND
.
12 Press ® to end the programming session.
0 new 0 saved
PLAY REC
ADMIN
Record message:
RETRY PAUSE OK
Accept rec?
RETRY PLAY OK
Mbox:
DIR QUIT
Address Type?
NETW AMIS
Dest Ph:
RETRY OK
<phone #>
ADD OK
Dest mb:
RETRY OK
AMIS msg:
OPTS CC OTHR
Network msg:
VIEW SEND
Commentaires sur ces manuels