Avaya CallPilot Message Networking Manuel d'utilisateur télécharger pdf (Page 20)

20 Chapter 2 Setting up Digital Networking

N0008713 01.1

Configuring DNS on CallPilot 100/150

1 Start CallPilot Manager.

2 Click the Configuration heading.

3 Click the Unit Address/Identification link.

The Unit Address and Identification page appears.

4 In the Host name or IP Address box enter your CallPilot’s Host name.

It must be a Fully Qualified Domain Name (FQDN.)

5 In the Primary DNS box enter the IP address of the external DNS server.

6 In the Secondary DNS box enter the IP address of secondary DNS server if you use one.

7 Click the Submit button.

8 You must reboot CallPilot for the new settings to take effect.

Warning: The FQDN must be in the same subnet that is specified by the Subnet

Mask and the Default Gateway IP address. If you enter an FQDN that is not in the

same subnet, you can cause the CallPilot to continuously reboot. To correct this

problem, use the serial interface to change the IP address of the CallPilot. For more

information, refer to “Changing the IP address using a serial cable” in the CallPilot

Installation and Maintenance Guide.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

Pas de commentaire

Avaya CallPilot Message Networking Manuel d'utilisateur Page 20