Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur télécharger pdf (Page 97)

Configuring RARP Services

4-5

Figure 4-2. RARP Interface Table Window

Parameter: Enable/Disable

Default: Enable

Options: Enable

| Disable

Function: Re-enables or disables the RARP interface you selected from the list of

interfaces.

Instructions: Select Enable to re-enable a disabled interface.

Select Disable to disable an interface.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.9.3.1.2

Deﬁning the RARP Mapping Table

To deﬁne the router’s MAC address-to-IP address RARP mapping table, begin at

the Conﬁguration Manager window (refer to Figure 1-3) and proceed as follows:

1. Select Protocols➔IP➔Reverse ARP➔Map Table.

The RARP Map Table window appears (Figure 4-3).

This window lists the clients on the network that can use the router’s RARP

services.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 107 108

Pas de commentaire

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur Page 97