Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur télécharger pdf (Page 13)

xiii

About This Guide

Read this guide to learn how to conﬁgure router or BNX software for the

following services:

• Simple Network Management Protocol or SNMP (Chapter 1)

• Bootstrap Protocol or BOOTP (Chapter 2)

• Dynamic Host Conﬁguration Protocol or DHCP (Chapter 3)

• Reverse Address Resolution Protocol or RARP (Chapter 4)

These services all use the Internet Protocol (IP) for message transport. To use one

of these services on a router interface, you must enable IP services on that

interface.

This guide provides the following information for each service:

• An overview of the protocol

• Issues you should consider when implementing the protocol

• Procedures for enabling the service on a Bay Networks router

• Procedures for tailoring parameters to meet your speciﬁc requirements

Software Suites

Routing and Switching software is available in the following suites:

• The

System Suite

includes IP routing, 802.1 Transparent Bridge, Source Route

Bridge, Translation Bridge, SNMP Agent, Bay Networks HDLC, PPP, OSPF,

EGP, BGP, and basic DLSw.

• The

LAN Suite

includes DECnet Phase 4, AppleTalk Phase 2, OSI, VINES,

IPX, and ATM DXI, in addition to the System Suite.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 107 108

Pas de commentaire

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur Page 13