
Configuring IP Multicasting and Multimedia Services
3-22
303527-A Rev. 00
Configuring an IGMP Boundary Group
You configure an IGMP boundary group by supplying a range of multicast group
addresses (expressed as an address and a prefix) and a list of IP interfaces. No
multicast group address that falls within the range you specify is accepted or
forwarded on the interfaces you specify.
You can use Site Manager to define an IGMP boundary group.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
IGMP
. The IGMP menu opens.
4. Choose
Boundaries
. The IP Boundary Group window opens.
5. Set the following parameters:
•Enable
• Group Address
• Prefix Length
• Circuit List
• Tunnel List
Click on
Help
or see the parameter
descriptions beginning on page A-51
.
6. Click on
Apply
, and then click on
Done
. You return to the Configuration Manager
window.
Commentaires sur ces manuels