
Configuring Router Redundancy
114079 Rev. A 5-11
Parameter: Role Switch Delay Period
Default: 5 seconds
Options: 1 through 86,400 seconds
Function: Currently not used.
Instructions: Accept the default.
MIB Object ID: 1.3.6.1.4.1.18.3.5.17.1.19
Configuring Resources
The redundancy protocol uses the Resource parameters to ensure that the primary
router in the router redundancy group can reach the devices with which you have
configured it to communicate. Use the procedure that follows to edit these
parameters.
Although you can edit Resource parameters either in group mode or in member
mode, usually it is best to configure Resource parameters in group mode because
they are identical for all members of a router redundancy group. The exception is
if you use router redundancy with wide area networks (refer to Example 3 in
Appendix B). In this case you configure resources differently among members of
a router redundancy group.
To edit Resource parameters:
1. Select Protocols > Edit Router Redundancy > Resources in the Circuit
Definition window.
The RREDUND Router Redundancy Resource List window appears
(Figure 5-6).
Commentaires sur ces manuels