Avaya Configuring Data Compression Services Manuel d'utilisateur télécharger pdf (Page 45)

Editing Data Compression Parameters

4-9

Editing WCP Circuit Interface Parameters

To edit WCP circuit interface parameters, begin at the Conﬁguration Manager

window (refer to Figure 4-1) and proceed as follows:

1. Select Protocols➔WCP➔Interfaces.

The WCP Circuit Interfaces List window appears (Figure 4-3).

Figure 4-3. WCP Circuit Interfaces List Window

Select the WCP circuit that you want to edit from the list in the top left

corner of the window.

The values in the parameter ﬁelds apply to the WCP circuit interface you

highlight.

3. Edit those parameters you want to change, using the descriptions

following this procedure as a guide.

4. Click on Apply to implement your changes.

5. Repeat Steps 2 through 4 for each parameter you want to edit.

6. Click on Done to exit the window.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52

Pas de commentaire

Avaya Configuring Data Compression Services Manuel d'utilisateur Page 45