Avaya Configuring Data Compression Services Manuel d'utilisateur télécharger pdf (Page 37)

4-1

Chapter 4

Editing Data Compression Parameters

This chapter provides information about customizing data compression

parameters for the Frame Relay, X.25, or PPP interfaces you conﬁgure.

For each WCP parameter, this chapter gives the default setting, valid parameter

options, the parameter function, instructions for setting the parameter, and the

Management Information Base (MIB) object ID. With the exception of the Engine

Type and Fallback Compression Mode parameters, these parameters apply to both

software- and hardware-based compression. The Engine Type and Fallback

Compression Mode parameters apply to hardware-based compression only.

The Technician Interface allows you to modify parameters by issuing set and

commit commands with the MIB object ID. This process is equivalent to

modifying parameters using Site Manager. For more information about using the

Technician Interface to access the MIB, refer to Using Technician Interface

Software.

After you enable compression, you can edit all data compression parameters from

the Conﬁguration Manager window (Figure 4-1). Refer to Conﬁguring Routers or

Conﬁguring Customer Access (BNX Software) for instructions on using Site

Manager to access this window. Then read the section that follows for the protocol

you are conﬁguring.

Caution: The Technician Interface does not verify that the value you enter for

a parameter is valid. Entering an invalid value can corrupt your

conﬁguration.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Pas de commentaire

Avaya Configuring Data Compression Services Manuel d'utilisateur Page 37