Avaya Configuring XNS Services Manuel d'utilisateur télécharger pdf (Page 61)

Editing XNS Parameters

4-25

Parameter: Target Network (hex)

Default: None

Options: Any valid network address in hexadecimal notation

Function: Speciﬁes the address of the network to which you want to conﬁgure the

static route.

Instructions: Enter a network address of up to 8 hexadecimal characters.

MIB Object ID: 1.3.6.1.4.1.18.3.5.10.6.1.3

Parameter: Next Hop Network (hex)

Default: None

Options: Any valid network address in hexadecimal notation

Function: Speciﬁes the network address of the next hop.

Instructions: Enter a network address of up to 8 hexadecimal characters.

MIB Object ID: 1.3.6.1.4.1.18.3.5.10.6.1.5

Editing a Static Route

You can edit the conﬁgurable parameters of a static route that you speciﬁed earlier

in the node conﬁguration. The Conﬁguration Manager does not allow you to

reconﬁgure the Target Network and Next Hop Network parameters for a static

route. If you want to change these parameters, you must delete the static route and

add a new route with the proper information. However, you can reconﬁgure all

other parameters associated with a static route.

To edit the conﬁgurable parameters associated with an existing static route, begin

at the Conﬁguration Manager window (F

igure 4-1) and select

Protocols➔XNS➔Static Routes. The XNS Static Routes window appears (refer

to Figure 4-7). From this window, proceed as follows:

1. Select the static route you want to edit. Click on the appropriate entry in

the list of static routes.

2. Click on any parameter value you want to change; then enter a new

value.

3. Click on Apply to save your changes.

4. Click on Done to exit the XNS Static Routes window.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 71 72

Pas de commentaire

Avaya Configuring XNS Services Manuel d'utilisateur Page 61