Avaya Configuring XNS Services Manuel d'utilisateur télécharger pdf (Page 31)

2-1

Chapter 2

XNS Conﬁguration Notes

Refer to this chapter when you are conﬁguring the following XNS services:

• XNS without RIP

• XNS on a Token Ring interface

Conﬁguring XNS without RIP

The router running XNS software learns WAN addresses from RIP broadcasts

received over WANs. The router stores the XNS address/WAN address pairs in its

RIP table for future determination of next-hop destinations.

Every router running XNS software on the internetwork learns about all the other

routers running XNS software through the propagation of RIP tables. These tables

can become very large in large internetworks.

You may want to conﬁgure XNS without RIP to control the size of these tables

and to reduce bandwidth. However, you must do the following when you

conﬁgure an XNS WAN interface without RIP:

1. Conﬁgure an adjacent host, and edit the DLCI parameter in the XNS

Adjacent Host Conﬁguration window for each host on an adjacent Frame

Relay or SMDS network.

Refer to “Conﬁguring Adjacent Host Parameters” in Chapter 4.

2. Conﬁgure a static route to the next-hop router for each adjacent host.

Refer to “Conﬁguring Static Route Parameters” in Chapter 4.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Pas de commentaire

Avaya Configuring XNS Services Manuel d'utilisateur Page 31