Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur télécharger pdf (Page 23)

Starting SNMP, BootP, DHCP, and RARP Services

303542-A Rev 00

1-5

Starting SNMP Services

You can use the BCC command line interface or the Site Manager graphical user

interface to start SNMP on the router, using default values for all parameters.

Before you begin, verify that you have configured IP on an interface, as described

in “Configuring IP for Global Protocols

,” on page 1-2.

Using the BCC

To configure SNMP on the router with default settings, begin in configuration

mode at the box-level prompt:

Configure SNMP.

box#

snmp

Display SNMP default settings.

snmp#

info

on box

state enabled

lock enabled

lock-address 0.0.0.0

lock-timeout 2

authentication-traps enabled

type-of-service reliability

scope-delimiter 0x40

Using Site Manager

You can easily start SNMP services using default values for all parameters. If you

decide to change some or all of the default values, refer to the instructions in

Chapter 3, “Customizing SNMP.” For a list of SNMP parameters, see Appendix

B, “Default Parameter Settings.”

Before you can start SNMP services, you must verify that you have configured IP

on an interface, as described in “Configuring IP for Global Protocols

,” on

page 1-2.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 145 146

Pas de commentaire

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur Page 23