Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur télécharger pdf (Page 120)

Configuring SNMP, BootP, DHCP, and RARP Services

A-6

303542-A Rev 00

SNMP Manager Parameters

Use the following guidelines to configure SNMP manager parameters in the

SNMP Manager window.

Parameter: Trap Port

Path: Configuration Manager > Protocols > IP > SNMP > Communities >

Community > Managers > Manager > Add Manager | Edit Manager

Default: 162

Options: 1 to 9999

Function: Specifies the number of the port on the management station to which the agent

sends traps.

Instructions: The standard port number for trap messages is 162; however, you may enter a

different port number. Be sure not to specify a port that another application uses.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.5.3.1.5

Parameter: Trap Types

Path: Configuration Manager > Protocols > IP > SNMP > Communities >

Community > Managers > Manager > Add Manager | Edit Manager

Default: Generic

Options: None

Generic

Specific

All

Function: Specifies the type of trap the agent sends to this manager.

Instructions: Select None to prohibit the agent from sending traps to this manager.

Select Generic to configure the agent to send the well-defined SNMP traps

(cold-start, warm-start, and authentication failure traps) to the manager. The

cold-start and warm-start traps are automatically active in the SNMP agent;

however, you must enable the Authentication Failure Traps global parameter for

the agent to send such traps to this manager.

Select Specific to configure the agent software to send all enabled log event

traps to this manager.

Select All to send cold-start traps, warm-start traps, and all enabled log event

traps to this manager.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.5.3.1.6

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 145 146

Pas de commentaire

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur Page 120