Avaya EE Networking Guide de l'utilisateur télécharger pdf (Page 18)

18 Using Enterprise Edge Services

Enterprise Edge Networking Operations Guide P0910464 Issue 01

Users must enter the following parameters:

• Initial IP and mask for all network interfaces

• Primary (and optional secondary) DNS servers

• Default next hop router

• Fractional T1 channel numbers (if you are using fractional TI)

• System name

• WAN Link Protocol

• Frame Relay DLCI / CIR (if applicable)

• V.90 modem dial-up username and password (if applicable)

• V.90 modem dial-up phone number and optional alternate phone number (if

applicable)

The following table describes the Enterprise Edge server connectivity options.

Setting up an Enterprise Edge IP Address

To manage the Enterprise Edge server using a web browser or a Telnet connection,

you must first set up the IP address. The Enterprise Edge server LAN interface is

shipped with default IP 10.10.10.1 and mask 255.255.255.0.

To set up the Enterprise Edge server initial IP address using a RS-232 port:

1. Turn on the Enterprise Edge server power switch.

2. Connect a PC or laptop computer to the Enterprise Edge server RS-232 port.

3. Start a hyper terminal on the PC or laptop computer.

4. Enter the LAN/WAN IP address and other parameters.

Field Definition

HTTP You can launch your JAVA-enabled browser to connect to the Enterprise Edge

server IP address that connects to your PC. This displays the log in screen. See

the Enterprise Edge log on screen

on page 20.

TTY You can connect a dumb terminal to the console of the Enterprise Edge server

through an RS-232 cross-over cable, or, you can use Hyperterminal from Win95/

Win NT systems. Refer to the installation guide for console menus.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 181 182

Pas de commentaire

Avaya EE Networking Guide de l'utilisateur Page 18