Avaya R2MFC Guide de configuration télécharger pdf (Page 62)

62 Chapter 5 R2MFC MBM maintenance

N0027684 01

Replacing an R2MFC MBM

When an R2MFC MBM requires replacement, follow the steps in this section.

Figure 22 on page 62 provides an overview of the process for replacing R2MFC MBMs.

Figure 22 Overview of module replacement process

If replacement of the R2MFC MBM is required, perform the follow steps to properly replace the

module:

1 Follow the steps in “Shutting down the system” on page 31 to ensure the system shuts down

correctly.

2 Remove all cables and disconnect the BCM from the AC power outlet.

3 Remove the front bezel from the unit in which the module resides.

4 Pull the latch beside the module to be replaced to release the module. Refer to Figure 9 on

page 36 or Figure 10 on page 36.

5 Slide the module out of the bay in which it is installed.

Warning: This section describes replacing a module with the same type of module. If you

want to replace a module with a different type of module, you must treat it as a new

installation. Refer to the Installation and Maintenance guide to ensure the new module

does not overrun any lines already assigned to other modules.

Firmware upgrade

required

Disconnect cables from

the front of the sever

and the expansion unit

Remove power from

both units

Remove front bezel

from expansion unit

Remove failed module

Set DIP switches on

new module to match

old module

Install new module in

media bay

Replace bezel

Restore power to BCM

and expansion unit

Check the module

settings in the Unified

Manager

Reconnect all cables

Monitor LEDs for power

and status

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 105 106

Pas de commentaire

Avaya R2MFC Guide de configuration Page 62