Avaya Configuring Dial Services Manuel d'utilisateur Page 49

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 428
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 48
Getting Started
114062 Rev. B 1-19
Configuring Circuits
To configure dial-up circuits, refer to the appropriate section for instructions:
•“Creating
Demand Circuits
•“Creating
Backup Circuits,” on page 1-25
•“Creating Bandwidth Circuits,” on page 1-28
When you create a PPP dial-up circuit, Site Manager creates a special PPP record
for the circuit, which identifies who is calling the router. This record is listed in
the PPP Interface Lists window as follows:
Interface for Dialup Lines
For more information about PPP, refer to Configuring PPP Services.
Creating Demand Circuits
To configure Frame Relay demand circuits, skip this section and go to Chapter 9.
To configure PPP demand circuits:
1. Begin at the Configuration Manager window (refer to Figure 1-1).
2. Select Dialup > Demand Circuits.
Site Manager displays the Demand Pools window, listing the new pools
(Figure
1-16).
Figure 1-16. Demand Pools Window Listing Configured Pools
Vue de la page 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 427 428

Commentaires sur ces manuels

Pas de commentaire