Avaya Using Technician Interface Software Manuel d'utilisateur Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 382
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
Using Technician Interface Software
xx
117381-A Rev. A
Before You Begin
Before using this guide to issue Technician Interface commands, you must
Install the hardware platform.
Use one of the following methods to establish a connection to the platform:
-- Connect the serial port of an ASCII terminal device (for example, a DEC
VT100) directly to the console port of the platform.
-- Connect the serial port of a workstation or PC directly to the console port
of the platform. (Run ASCII terminal emulation software on the
workstation or PC.)
-- Dial in to the console port of the platform from a workstation or PC
running ASCII terminal emulation software. This alternative requires one
modem locally attached to your workstation or PC, and another modem
locally attached to the console port of the platform you want to access.
-- Establish a Telnet (in-band) connection to the platform.
Note:
Before you can access the Technician Interface using Telnet, the
platform must have at least one assigned IP address. Although there is no limit
to the number of Telnet connections that you can make to the Technician
Interface, we recommend that you establish no more than one Telnet session
per platform.
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 381 382

Commentaires sur ces manuels

Pas de commentaire