Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur Page 139

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 178
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 138
Troubleshooting Network Boot Problems
114074 Rev. A A-11
The possible boot image and boot config settings are network and local.
If the setting is
network, the AN/ANH requests the boot image or configuration
file from a BOOTP server when booting. If the setting is
local, the AN/ANH
uses the boot image or configuration file stored in the Flash card file system.
The
XCVR parameter shows the current setting of the AN/ANH Ethernet
connectors. The
COM parameters show the current settings of the AN/ANH
synchronous connectors.
The possible settings for synchronous connectors are as follows:
EZ-Install (the default setting)
The IP address, next-hop IP address, subnet mask, and WAN protocol (Bay
Networks HDLC or Frame Relay)
The possible settings for Ethernet connectors are as follows:
None (the default setting)
The IP address with subnet mask
See
Chapter 5 for instructions on using the ifconfig and bconfig commands to
change the parameter settings.
Vue de la page 138
1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 177 178

Commentaires sur ces manuels

Pas de commentaire