Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur télécharger pdf (Page 157)

SNMP, BootP, DHCP, and RARP Parameter Descriptions

117362-C Rev 00

A-21

BootP Client Interface Address Parameters

Use the following guidelines to configure BootP and DHCP parameters in the

BOOTP Client Interface window.

Parameter: IP Address

Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface

Table >

Client I/F

Add

Default: None

Options: Any valid IP address

Function: Specifies the IP address of the remote AN that will boot using EZ-Install over a

frame relay group access PVC connection to the router.

Instructions: Enter the IP address of the remote AN.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.3

Parameter: DLCI Number

Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface

Table >

Client I/F > Add

Default: None

Options: 16 to 1007

Function: Specifies the frame relay PVC identification number whose destination is the

remote AN that will boot using EZ-Install. The frame relay network uses the

DLCI number to direct data flow.

Instructions: Enter the DLCI number, in decimal format, for the group access PVC to the

remote AN. Use the DLCI number assigned by your frame relay service

provider.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.2

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 175 176

Pas de commentaire

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manuel d'utilisateur Page 157