Avaya Configuring BOOTP Services Manuel d'utilisateur télécharger pdf (Page 25)

Starting SNMP, BootP, and DHCP Services

308644-15.1 Rev 00

1-5

Starting SNMP Services

You can use the BCC command-line interface or the Site Manager graphical user

interface to start SNMP on the router, accepting default values for all parameters.

SNMP is globally enabled on the router by default when you install BayRS

software. By default, the Quick-Start installation script (install.bat) creates a

read/write SNMP community named “public” with a wildcard manager (0.0.0.0)

that allows universal read/write access. You should restrict read-write access to the

router as soon as possible by reconfiguring the security of this SNMP community.

When you add SNMP with the BCC, access is defined by default as read-only.

If you decide to change some or all of the default values, refer to the instructions

in Chapter 3

, “Customizing SNMP.”

Before you begin, verify that IP is configured on an interface, as described in

“Configuring IP for Global Protocols

” on page 1-2.

Using the BCC

To configure SNMP on the router with default settings, begin in configuration

mode at the box or stack prompt:

Configure SNMP.

box#

snmp

Display SNMP default settings.

snmp#

info

lock enabled

lock-address 0.0.0.0

lock-timeout 2

authentication-traps enabled

type-of-service reliability

state enabled

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 195 196

Pas de commentaire

Avaya Configuring BOOTP Services Manuel d'utilisateur Page 25