Avaya CallPilot Message Networking Manuel d'utilisateur télécharger pdf (Page 30)

30 Chapter 3 Setting up AMIS

NN40090-301NN40090-301

4 Set the Dialing Translation properties:

5 Click Submit.

Building a Dialing Translation Table

To build a Dialing Translation Table, you must enter an Input value and an Output value for each

entry. The Input value is the number that the system looks up in the Dialing Translation Table. If

the corresponding entry matches, the system substitutes the Output value for the Input value. The

resulting number is ready to dial on the local network. Refer to “Examples of Dialing Translation

Tables” on page 27 for examples of Dialing Translation Tables.

To build a Dialing Translation Table

1 Start CallPilot Manager.

2 Click the Configuration heading.

3 Click the Dialing Translation Table link.

The Dialing Translation Table page appears.

Long Distance Access Code

This prefix is removed from any numbers that do not require it to make

the call. This simplifies creating the Dialing Translation Table. For

North America, set the long distance access code to 1. The default for

this property is none. The length of this property is a maximum of two

digits.

Area Code

The system prefixes an area code to a phone number if the caller who

entered the number did not enter an area code. If the addressing

information attached to a message is missing an area code, the area

code is prefixed to the number. The system considers the area code

missing if the number has fewer than 10 digits. The default for this

property is none. The maximum length of this property is 6 digits.

Access Code

After Dialing Translation, this number prefixes all numbers, to access

the local telephone network. The access code is required if CallPilot is

installed behind a PBX. In North America, the access code is usually

9. If CallPilot is connected directly to CO lines, set the Access Code to

none. The default for this property is none. The maximum length of

this property is 16 digits.

Enable Reply Translation

If Enable Reply Translation is selected, then the reply feature uses the

dialing translation table to dial the call.

If you want to enable reply translation, select this box.

The default for this property is not enabled.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 77 78

Pas de commentaire

Avaya CallPilot Message Networking Manuel d'utilisateur Page 30