Avaya 1000 Series Video Conferencing Systems Guide d'installation télécharger pdf (Page 8)

Configuration of SIP video endpoints on Communication Manager 6.0

AVTS R 6.0 Quick Setup For feedback, use doc[email protected] August 2010

Administration of Avaya Series 1000 Video Conferencing and

Avaya one-X

Communicator video endpoints and users using

System Manager

Perform the following steps to configure all Avaya Series 1000 Video Conferencing Endpoints

and Avaya one-X

Communicator with SIP video. This section describes how to use System

Manager to create an endpoint template and how to add users using these templates.

Creating a template

Table 2: Creating a template

Creating a custom template for any SIP endpoint on System Manager

1. Click Elements > Templates > Endpoint, select Communication Manager 6.0

on the Endpoint Templates page and click New. Set the following

parameters:

● Set Type : 9630SIP, an alias for the 1000 series endpoints

● Template Name : Avaya recommends naming the template according to its

AV10x0 type and Communication Manager release, such as

AV1010_CM_6_0.

● COR : 1

● COS : 1 or an appropriate cos group for priority video calling and bit-rate

management

Note:

Note: This applies to priority video users and is not required for minimal

administration. See Avaya video Conferencing Solutions Networking

Guide 6.0 for further details.

● SIP trunk : AAR or specific SIP trunk used between System Manager and

Communication Manager

2. Select the IP video check box.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Pas de commentaire

Avaya 1000 Series Video Conferencing Systems Guide d'installation Page 8