
Configuring IP Multicasting Services
5-16 114064 Rev. A
Configuring the Neighbors Forwarding Table
You can use Site Manager to store the following information about an ST2
neighbor in the neighbors forwarding table:
• Whether the record for this neighbor is active.
• Whether the neighbor is capable of route exploration.
• Whether the router should send Hello messages to the neighbor. The hello
Protocol parameter also specifies the type of hello procedure. (Select Enable
to use the normal Bay Networks hello procedure. Select Hello When Stream
Active to use the hello procedure only when a stream is running to a
neighbor.)
• The type of connection to this neighbor.
• A priority value for the neighbor. If you enter multiple ST2 route exploration
neighbors in the forwarding table, use the Neighbor Priority Level parameter
to rank them. First choice is the neighbor with the lowest value.
• The IP address of the next-hop neighbor -- router or host.
Site Manager: Enable parameter: page A-24
Site Manager: Route Exploration Capability parameter: page A-25
Site Manager: Hello Protocol parameter: page A-25
Site Manager: Neighbor Type parameter: page A-25
Site Manager: Neighbor Priority Level parameter: page A-26
Site Manager: Next Hop IP Address parameter: page A-26
Commentaires sur ces manuels