Avaya FRE-2 Manuel d'utilisateur télécharger pdf (Page 36)

Upgrading the FRE-2 Processor Module

14 108305 Rev. D

1. To reassemble a BLN or BLN-2 router, slide the top of the board retainer

bracket into its designated ridge and align the bottom of the bracket with

the screw hole at the bottom of the chassis (refer to Figure 6). (To

reassemble a BCN router, skip to Step 3.)

2. Use a Phillips screwdriver to secure the board retainer bracket to the

chassis.

3. Disconnect the wrist strap from the chassis.

4. Replace the EMC shield as follows:

a. Position the EMC shield in front of the chassis.

b. Tighten the captive thumbscrews that fasten the EMC shield to the

chassis.

5. Insert the wrist strap into its package at the back of the front bezel.

6. Replace the front bezel as follows:

a. Align the mounting retainers on the inside of the bezel with the holes

on the front of the EMC shield.

b. Push the sides of the bezel into place.

Once the front bezel is in place, the FRE-2 processor module upgrade is complete.

1 2 ... 31 32 33 34 35 36

Pas de commentaire

Avaya FRE-2 Manuel d'utilisateur Page 36